辐射防护通讯 ›› 2019, Vol. 39 ›› Issue (1): 7-10.

• 研究通报 • 上一篇    下一篇

电子束氨法脱硫反应器内部剂量率的模拟计算

王棋赟1,2, 李建军1, 李升华2   

  1. 1.四川大学建筑与环境学院, 成都, 610065;
    2.国家电投集团远达环保工程有限公司, 重庆, 4011222
  • 收稿日期:2018-09-17 发布日期:2019-10-29
  • 通讯作者: 李建军(1963— ),812405920@qq.com
  • 作者简介:王棋斌贝(1984— ),男,2007年毕业于四川大学核工程与核技术专业,学士; 四川大学建筑与环境学院环境工程硕士在读; 工程师; 注册核安全工程师。从事放射性三废处理研究。
  • 基金资助:
    国家自然科学基金项目(51378325)——基于烟气多种污染物脱除的炭基催化剂及催化净化机理研究。

Simulation Calculation of Internal Dose Rate in EA FGD

Wang Qiyun1,2, Li Jianjun1, Li Shenghua2   

  1. 1. College of Architecture and Environment, Sichuan University, Chengdu, 610065;
    2. SPIC Yuanda Environmental Protection Engineering CO., Ltd., Chongqing, 401122
  • Received:2018-09-17 Published:2019-10-29

摘要: 为验证MCNP用于计算电子束氨法脱硫反应器内部剂量率的可行性,本文借用“小孔成像”的原理对能量为0.57 MeV的电子加速器进行模拟,计算电子束氨法脱硫反应器内部的剂量率分布,并与文献中的实验测量值以及EGS4程序模拟值进行比较。结果表明:MCNP程序计算所得到的反应器内部剂量率分布在25.7%误差下的结果与EGS4程序模拟结果一致。

关键词: 电子束氨法脱硫, 小孔成像, 蒙特卡罗方法

Abstract: In order to verify the feasibility ofMCNP for calculating the internal dose rate of an electron beam ammonia desulfurization vessel, the principle of “pinhole imaging" is employed to simulate an electron accelerator with energy of 0.57 MeV. The dose rate is then calculated, and compared with experimental measurements in the literature and the simulationvalues with the EGS4 program. It shows that the MCNP program calculation resultsat 25.7% error are consistent with those from the EGS4 program simulation.

Key words: EA FGD, Pinhole imaging, Monte Carlo method

中图分类号: 

  • TL501+.5